AR Sponsor
Posted: 5/22/2011 10:48:59 AM EDT
I've got a .22 cal upper that I decided to put some triangle hand guards on to give it a quasi retro look. I purchased a set of new in the wrapper triangle guards off GunBroker and installed them. I noted that the vent holes seemed to get more out of alignment right hand to left hand as I looked from the end cap to the delta ring. For "new in the wrapper" hand guards I'm a little disappointed since they also had a few "blister" looking areas as well as a scratch and gouge or two. They did install without a problem though. I figured I'd put this question here in the retro forum since I guessed my chances were better getting an answer here. So, my question is; is this misalignment normal to triangle hand guards or did I get a bad set of "new" grips?
 
|
AR Sponsor