[ARCHIVED THREAD] - Trigger locking

Posted: 3/17/2009 2:44:26 PM EDT

I just replaced my lower parts in my AR-15 when I took it out and shot it it did fine but on the 6 shot my trigger locked up and would not move.
the back of the trigger is able to move a little from side to side and gets hung up on the selcetor switch. the lower is made by E.A. Co.
I took it apart agian and by looking at the selector switch the area that the trigger goes into is wider on the old selector switch. is there an easy fix or do I need to have the selector switch
turned to make it wider?

Posted: 3/17/2009 2:48:21 PM EDT

[#1]

Have you checked to make sure there aren't any spent primers in the area? Sometimes a primer will back out after a case is fired and fall into the trigger group area.

Posted: 3/17/2009 2:59:46 PM EDT

[#2]

Thank you, but there was nonthing in the trigger group area.

[ARCHIVED THREAD] - Trigger locking

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - Trigger locking

[ARCHIVED THREAD] - Trigger locking