[ARCHIVED THREAD] - Vice block question.

Posted: 10/23/2014 5:59:00 PM EDT

I just traded another member for a vice block, and upon test fitting it on an A2 and A3 receiver, I noticed the bottom of the block allows a little bit of wiggle, is this normal? When I use it, should I put a little shim stock on either side of the takedown pin hole? Don't wanna ruin an upper if it can be avoided.

Also, should I leave the BCG in the upper to prevent crush damage? Or just be careful?

Thanks,
Chuck

Posted: 10/23/2014 7:12:19 PM EDT

[#1]

A vice block should come with a plastic insert the same size as a bolt/carrier. This will allow you to tighten the vice block enough to prevent movement without crushing the receiver.

Posted: 10/23/2014 7:17:59 PM EDT

[#2]

Quote History

Quoted:
A vice block should come with a plastic insert the same size as a bolt/carrier. This will allow you to tighten the vice block enough to prevent movement without crushing the receiver.

View Quote

In absence of said plastic piece, can the BCG be substituted? Got the block second hand, knowing that the insert was not with it.

Posted: 10/23/2014 7:55:56 PM EDT

[#3]

Yes, any 1" rod, dowell or Mechanics socket with a 1" od will also suffice.

Posted: 10/23/2014 8:43:08 PM EDT

[#4]

I use a wood dowel

Posted: 10/24/2014 11:52:11 AM EDT

[#5]

not all vice blocks come with the insert.

a wooden hardwood dowel is what I use

Posted: 10/24/2014 11:58:36 AM EDT

[#6]

My ProMag Vise Block Set I use has the plastic dowel piece. Works Perfect

[ARCHIVED THREAD] - Vice block question.

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - Vice block question.

[ARCHIVED THREAD] - Vice block question.