AR Sponsor
Posted: 10/22/2011 8:10:33 PM EDT
If I were to go with a slipover type FH such as in the photo, on a 14.5in barrel, would it be legal to just to a tack weld on the underside joint where the barrel and FH meet or would I have to drill a hole in it and pin it as well?
|
|
Quoted:
Quoted:
Four equidistant welds or one continuous weld around half the circumference. So If I just get the bottom half of the joint welded I'd be NFA safe with no pins? Just wanna be sure haha I don't think I'd look good in orange  check with the atf. the only two methods ive heard were 1100 degree silver solder and blind pin welding. ive never heard 4 tack welds or the bottom half done. reguardless, just blind pin it. not only is it less heat its also fairly easy to remove should you want to/need to remove the muzzle device. physically welding the device to the barrel isnt going to allow you to remove it later. |
|
Quoted:
Quoted:
Quoted:
Trust me bro, I'm right on this. Were right. ATF no longer allows the 4 tacs. Seam weld at least halfway around, hitemp silver solder, or blind pin and weld are still gtg, last i read. Which method requires the least ammount spent on tools? Blind pin and weld. |
Thanks for the help anyway guys!
|
Quoted:
Quoted:
Trust me bro, I'm right on this. Were right. ATF no longer allows the 4 tacs. Seam weld at least halfway around, hitemp silver solder, or blind pin and weld are still gtg, last i read. Hmmm. I had a suppressor tacked on in four places this year. Ruh roh! |
AR Sponsor