AR Sponsor
Posted: 5/25/2010 2:42:53 PM EDT
|
Hey guys I have a quick question about my build, I am running a 20in YHM fluted barrel and a YHM low pro gas block that use 2 set screws.
My question is, since there is no set screw holes on the bottom of the barrel will I just be able to use this gas block? Will I just crank down Snug the set screws in place and loctite them? Or do I need to get a new gas block? If so which one? Thanks in advance 
This is the gas block http://www.jsesurplus.com/yhmlowprofilegasblockshort.aspx And the barrel http://www.jsesurplus.com/yhmar15barrelcarbinelength-4.aspx |
| You can get your gas block in the correct place, take one screw out dimple the barrel with your drill. then put in set screw and repeat process for other one. In a perfect world this will all be done after you assemble and shoot it so you know it will cycle properly. I did mine without doing that and haven't had any problems but I'm not saying you wont. |
AR Sponsor