Warning

 

Close
Confirm Action

Are you sure you wish to do this?

Cancel Confirm
20414 Online
bravocompany bravocompany bravocompany
brownells brownells
tnvc tnvc tnvc
AR15.COM
bravocompany
My Account
bravocompany bravocompany bravocompany
brownells brownells
tnvc tnvc tnvc
JRH
primaryArms
aim
colt
cz
midwest
magpul
GS
fightlite
vortex
DFC
Guns
RS
palmetto
skd
OSIGHT
springfield
geissele
brownells
bravocompany
silencerShop
Holosun
20414 Online
aim
bravocompany
colt
OSIGHT
RS
GS
DFC
brownells
palmetto
Holosun
Guns
fightlite
midwest
JRH
skd
geissele
silencerShop
cz
magpul
springfield
vortex
primaryArms
AR Sponsor
Site News Could You Have Stopped This? Vegas Shooting Analysis with Attorneys on Retainer
2/10/2004 11:44:41 AM EDT
Does anyone have a solution that allows for a removable or fixed front sight for the bull barrel dpms (low pro I think) 22lr upper and a rock river removable carry handle?
2/11/2004 1:14:33 PM EDT
[#1]
One solution would be to have a gunsmith turn the barrel down in front of the handguard and then install a front sight base.  

You might check out some of the DCM-type sites and see if anybody makes a front sight that fits on the heavier barrel profiles.
2/11/2004 7:25:39 PM EDT
[#2]
I bought a bull barel front sight from DPMS; this has a .995" hole which I had a local machine shop drill out to 1.001" which then could be fitted over the 22LR barrel. (This was a VERY tight fit. If I were doing it again, I would probably get the hole enlarged to 1.01".) This is paired with an A3 carry handle rear sight, and it works.

O.P.
2/11/2004 7:30:42 PM EDT
[#3]
The front sight is dpms BL-18B and it starts out at .936" (corrects my previous post)

O.P.
AR Sponsor
colt
gray
SAS
springfield
primaryArms
ar15com
LAPG
CA
cmmg
ar15com
bravocompany
palmetto
Faxxon
blackhills
RS
geissele
LAPG
ar15com
silencerShop
Pro2A
THBRD
brownells