[ARCHIVED THREAD] - how does this grip attach?

Posted: 3/25/2005 2:40:50 PM EDT

Is this a QD type grip that attaches by twisting the bottom , or one that i have to use the little wrenches to attach?

link

Posted: 3/25/2005 2:59:14 PM EDT

[#1]

For less than $10 you couldn't go wrong either way (for plinking, etc.)

Posted: 3/25/2005 3:00:25 PM EDT

[#2]

This attaches to a rail on the handguards. It looks like it attaches by screwing the bottom. I have a simular setup.

Posted: 3/25/2005 3:14:59 PM EDT

[#3]

Quoted:
For less than $10 you couldn't go wrong either way (for plinking, etc.)

Your right, but i just hate the hassle of havin to pull out the wrenches to get it on and off. I think i will go ahead and get it. Thanks.

Posted: 3/25/2005 3:51:51 PM EDT

[#4]

I got one from CDNN with a aluminum rail to attach it to my handgaurd. It was one of the best $14 I have spent. The only mod it needed was a razor ran down the sides to smooth the molding joint line. It is removeable and adjustable in seconds and is tough like a glock frame.

Posted: 3/25/2005 4:12:16 PM EDT

[#5]

I had that same exact grip on my Bushmaster with YHM 2 piece hand guards. It lasted about 4 months and then it broke hehe. Shipping was a lot as I remember from that site.

I decided to go with the Tango Down grip after that, it was 61.00 shipping included. I think it was worth it for the upgrade. Now that other grip worked fine and everything, I just abused it to much and the plastic attached to the rails eventually cracked.

[ARCHIVED THREAD] - how does this grip attach?

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - how does this grip attach?

[ARCHIVED THREAD] - how does this grip attach?