AR Sponsor
Posted: 2/20/2011 8:18:51 PM EDT
|
Putting my spikes lower together with a DD LPK. Never used a DD LPK before and heard alot of good about them.
Was about to put the trigger guard in and noticed the pin used is an allen head screw? do they all come this way? |
| They come with a Magpul trigger guard. On the back hole ( The one closest to the grip)Tap the roll pin in whille supporting the "Ears of the reciever with a block. Use a roll pin punch with a nub on the tip so the pin doesn't deform. Then put the set screw in the front hole and screw it in with a allen wrench until the top of the screw is just below the level of the reciever tab. Getting this screw lined up with the hole in the trigger guard is a pain, but it will go. |
|
Quoted:
Understood all that thanks.... Do u know what size the Allen screw is? Don't have one that small gonna have to go buy one. Just buy a set a of allen wrenches. Get a metric set too. And if you're on a tight budget, get a set of these. Start building a set of tools for yourself. 
|
|
Quoted:
Quoted:
Understood all that thanks.... Do u know what size the Allen screw is? Don't have one that small gonna have to go buy one. Just buy a set a of allen wrenches. Get a metric set too. And if you're on a tight budget, get a set of these. Start building a set of tools for yourself. What I did. 1/16" is what you need to install this. |
| Cool, so 1/16 it is. I'm going to have to go buy me a set. I have some bigger sizes.....just not one to fit that screw. That's exactly what i am trying to do. Slowly build me up a little AR Tool box and have everything in it needed to completely tear it down and build it back up. Thanks for the help guys. |
AR Sponsor