[ARCHIVED THREAD] - magpul Trigger guard

Posted: 3/2/2010 6:10:44 AM EDT

how does the magpul tac trigger fit and match up with a RRA lower?

Posted: 3/2/2010 6:14:40 AM EDT

[#1]

if you mean enhanced trigger guard it will fit but I noticed mine has almost a purple tint to it compaired next to my noveske lower

Posted: 3/2/2010 6:30:25 AM EDT

[#2]

I have the enhanced aluminum guard from magpul on my RRA...it fits and matches up very well, only trouble I had was getting the roll pin in. Very very tight!!!

Posted: 3/2/2010 6:46:13 AM EDT

[#3]

Had that same problem putting in the regular trigger guard's roll pin, It was tuff any suggestions?

Posted: 3/2/2010 7:10:39 AM EDT

[#4]

No problems with mine I like the way I can get lower on the trigger now. I did the Al version not the plastic.

Posted: 3/2/2010 7:33:05 AM EDT

[#5]

Support the receiver at the roll pin.
Use the right size punch.
Moly grease on the new pin.
Roll pin starter punch to start pin straight (easier).
Roll pin punch to drive pin home (easier).

Several posts by people who used a vise or vise grips to squeeze some pins in.
A small arbor press would probably work well for this.

Posted: 3/2/2010 9:11:52 AM EDT

[#6]

I used a small hard rubber mallet to knock it in using a wood block to support the ears. Finished it up with a roll pin punch. Patience is key. (Edit: This was on a Spikes lower.)

[ARCHIVED THREAD] - magpul Trigger guard

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - magpul Trigger guard

[ARCHIVED THREAD] - magpul Trigger guard