Armory Sponsor
Posted: 1/22/2014 11:47:06 AM EDT
|
Can anyone recommend a good company that they've used that does Bulk Brass Processing? I've accumulated a lot and would like to have it processed for a reasonable price. Going rate seems to be $35 to $50/1000 for depriming, sizing, trimming and tumbling.
Any experience regarding a company you've used would be helpful. |
|
i hate processing brass so im constantly looking for ways to speed it up that wont break the bank. if you have a Dillon press, you can get your press set up with that aftermarket press mounted swager for around $80 bucks. then buy the Dillon power trimmer and size, swage and trim in one setting.
for us with a Hornady press, were SOL with the above mentioned set up. for me, i size on a single stage, then trim with a CTS trimmer powered by my drill press, and then use a VLD on my drill press. swage with a dillon bench swager and you're golden. there is a Powered units CTS makes you can get off ebay that has a few cases prep stations going on at the same time that looks amazing. |
| I've had several people do it. It's not worth the time for me with my current work schedule. There are two on the ee currently that do good work. I used to use Danny Henry and hope he'll come back. I haven't had any issues. Cost with shipping both ways on full flat rates runs about 5 CPR. |
Armory Sponsor