Armory Sponsor
Posted: 4/4/2013 9:16:40 AM EDT
| I have about 2k rounds of .223 that have already been cleaned deprimed and sized. I would like to get them trimmed and the primer pockets swaged. Is there anywhere out there that still offers a case trimming service? |
|
I used to use this guy Danny in Texas but he unfortunately retired. He saved my hands a lot of pain from my manual Lee trimmer. He charged like $30-40 per K or something but was shut down due to health issues. He was widely used on the forums and did a great job. He did a clean cut, no chamfer but I never had any problems at all with seating bullets. If he is up and running again (there were reports last August he was taking some orders) I can't make a better recommendation.
I do not think he is still in business however since his website is down. PM Me and I can send you his email. Me however, I unfortunately process brass myself now. I am too cheap to buy a Giraud and would consider a Dillon except the fact you need seperate motors and all to trim both 223 and 6.8 SPC. I did buy a Lee Quick Trim that is at least press mounted and is quick unless your brass is about .010" or so too long then its a pain. If the brass is just a hair longer than your trim length it goes quick. Anyways you didn't ask about trim method so I'll end my rant. 
|
|
Quoted:
Quoted:
Quoted:
Look for that service in the EE. Equipment Exchange button. Got link? I looked and couldnt find anybody. Top right part of page. Orange colored button! CavVets been here since 01 I'll guessing he knows where the EE is 
Wonder if a trim die for 6.8 from CH4D would work in the regular trimmer as the 300blk does |
Armory Sponsor