Warning

 

Close
Confirm Action

Are you sure you wish to do this?

Cancel Confirm
AR15.COM
Armory Sponsor
1/21/2009 1:28:51 PM EDT
Is it legal to replace a registered receiver that has worn out?  I know during the AW ban days you could replace a damaged magazine with new parts, just wondering if you can do the same thing with Class III?
1/21/2009 3:27:50 PM EDT
[#1]
No.

Once a NFA MG wears out or NFA sear breaks it cannot be replaced.  In the eyes of the ATF if a transferable NFA receiver is worn out it cannot be replaced, because the replacement receiver would be creating a new post '86 machine gun. This means there would be another NFA gun off the registry and someone will be out a lot of cash.

There may be a chance to fix a receiver IF the serial number will not be touched in any way, but I could be wrong about that.
1/21/2009 3:58:43 PM EDT
[#2]
May be repaired, but not replaced.

Olympic arms recently got their fingers slapped by the BATF for "remanufacturing" transferrable pre-86 RR's.

Personally, I would not touch one of these with a 10-ft pole - they are prime pickens for NFA confiscation when they get the whim ....... just look at the BRP XMG debocle - 5-years into manufacture and the BATF decides that the are posties when installed on an M16 receiver ...................
1/22/2009 5:17:12 AM EDT
[#3]
Quoted:
May be repaired, but not replaced.

Olympic arms recently got their fingers slapped by the BATF for "remanufacturing" transferrable pre-86 RR's.

Personally, I would not touch one of these with a 10-ft pole - they are prime pickens for NFA confiscation when they get the whim ....... just look at the BRP XMG debocle - 5-years into manufacture and the BATF decides that the are posties when installed on an M16 receiver ...................


oly got a pee-pee slap because they were remanufacturing lowers that had been converted by a third-party. even though they were the original manufacturer of the reciever, they were NOT the manufacturer of the *machinegun*.

outside of that though, no. you cannot replace an old or busted MG recievers. you can repair them, but not replace.

1/22/2009 8:26:38 AM EDT
[#4]
Repair not replace is the safe bet.  I thought however that if the old reciever was compleatly destroyed and a replacement was made with the same serial # and proof of destruction of the old, that it could be done, but then again, the ATF like to change its mind as much as a woman does.
1/22/2009 8:30:56 AM EDT
[#5]


Quoted:


Repair not replace is the safe bet.  I thought however that if the old reciever was compleatly destroyed and a replacement was made with the same serial # and proof of destruction of the old, that it could be done,


Unfortunately, no.



 
Armory Sponsor