Armory Sponsor
Posted: 5/31/2013 6:58:43 AM EDT
|
So I am in the market for a PS90 and I have already have a suppressor that supports 5.7x28 that is threaded in 1/2x28. Is there anyway to make this work? I do not want to SBR it! I keep getting some conflicting information on the interweb about this topic. Any one have any experience with this or even better pictures?
Thanks!!!! |
|
If you remove the flash hider (which has a pin that must be drilled), the barrel will be under the minimum length that is legal. Be aware of that....
There are/were an 18" aftermarket barrel - I forget who makes it. The Fn Forum probably has reference to it someplace. To surpress it, you will have to SBR unless you buy that 18" barrel |
|
This might interest you...
http://www.youtube.com/watch?v=vhqYYqvIZa4 |
|
I have not seen that yet.. That is super exciting but seems like it might be some time before this comes to market. I am going to get PS90 and either end up SBR it or wait for one the Hunter shrouds to come out.. Thank you to everyone for the info!! |
|
As installed in that video, it would not be legal unless the receiver was registered as a SBR. The shroud must be permanently attached to the 16" barrel to keep the OAL over 26". |
Armory Sponsor