Warning

 

Close
Confirm Action

Are you sure you wish to do this?

Cancel Confirm
AR15.COM
Armory Sponsor
9/8/2013 7:54:32 PM EDT
Just opened it, got everything set up and ready to trim around 500 rounds of brass. I made it two pieces and the motor goes down. Extremely pissed over this product. I will be calling RCBS in the morning to do something about it.
9/8/2013 8:15:20 PM EDT
[#1]
Sure its plugged in good? didn't throw a breaker ?
9/8/2013 8:18:56 PM EDT
[#2]
Quote History
Quoted:
Sure its plugged in good? didn't throw a breaker ?
View Quote

Yes. Changed plug ins through out the house. Checked all the sauters on the wires and its all good, motor wasnt hot but it only ran around 5 minutes.
9/8/2013 8:40:50 PM EDT
[#3]
Quote History
Quoted:

Yes. Changed plug ins through out the house. Checked all the sauters on the wires and its all good, motor wasnt hot but it only ran around 5 minutes.
View Quote View All Quotes
View All Quotes
Quote History
Quoted:
Quoted:
Sure its plugged in good? didn't throw a breaker ?

Yes. Changed plug ins through out the house. Checked all the sauters on the wires and its all good, motor wasnt hot but it only ran around 5 minutes.



Atleast its RCBS ..... you'll get a refund or a new one next week
9/8/2013 8:45:28 PM EDT
[#4]
I'm guessing you got a bad switch.  Sorry for your PITA.  Of course you know RCBS will take care of it, but you're out a week at least.  I'd test for a bad switch by wiring the cord directly to the motor.  It if then works you know it's the switch....if not the motor....and boy that would be a rare one indeed!





If it was mine and I determined it was the switch, I'd ask them to send me a new switch, and while waiting, just plug it in direct.  Then I wouldn't lose case prep time.



When you get it running, please write a review for the tool!


       
 
 
9/8/2013 8:51:38 PM EDT
[#5]
Check the external safety switch carefully, and make sure its not jammed in the "keep the motor off" position.
9/8/2013 8:53:51 PM EDT
[#6]
Quote History
Quoted:
I'm guessing you got a bad switch.  Sorry for your PITA.  Of course you know RCBS will take care of it, but you're out a week at least.  I'd test for a bad switch by wiring the cord directly to the motor.  It if then works you know it's the switch....if not the motor....and boy that would be a rare one indeed!

If it was mine and I determined it was the switch, I'd ask them to send me a new switch, and while waiting, just plug it in direct.  Then I wouldn't lose case prep time.

When you get it running, please write a review for the tool!
           
View Quote

I will try that. And it is RCBS so I know I will get a full refund but man, I sold my cam lock trimmer and have no other way to process brass right now. A review is a must! I was going to do it after this run, but I suppose it will wait. Thanks.
9/9/2013 8:06:30 AM EDT
[#7]
I have one of these on order. I've been trying to get one since June but they didn't have a part to manufacture them.   I should have it pretty soon.
Armory Sponsor