Armory Sponsor
Posted: 11/3/2010 6:45:22 PM EDT
|
Searched to no avail
Just got my new safe yesterday and I'm starting to move my cache from a family member's safe into mine. The problem is, I can't get the code to reprogram from the factory's code. The instructions say with the bolts extended, enter six zeros and you should hear a double beep. When I do this, all I hear is a long beep. I went through with the instructions, just for the hell of it, but can't get it to reprogram. any ideas? Here's a factory pic. When it lightens up tomorrow, I'll take a good pic of the actual safe for the photo thread 
|
|
Quoted:
I think what he was saying was there may be lock programming instructions for more than one different type of electronic lock in your owner manual. He was saying to make sure your using the right instructions. I understood him, actually and was pointing out that I'm a fool because I didn't think to turn the page on the manual. I saw that the booklet had instructions in different languages, so I assumed that there was only one set of instructions for each language. After he responded, I looked closer and realized there were two pages in each language. The second page did the trick |
Armory Sponsor