[ARCHIVED THREAD] - Ruger 10/22 problem

Posted: 9/20/2008 9:20:45 AM EDT

When you shoot it chambers a new round fine, the hammer locks back but it doesn't release when you pull the trigger. I have found out that if you pull the bolt back until it clicks it will release the hammer. Or I half to push the trigger forward towards the muzzle to be able to pull the trigger so the hammer will fall.
I have tried Winchester federal and high velocity stingers.
I have also replaced the stock, happens on factory/ 25 rounder mags.
Please help me

Thank you

Posted: 9/20/2008 1:32:07 PM EDT

[#1]

Sounds like the trigger is not reseting. Check the spring and detent behind the trigger and also the channel that the spring and detent ride in. Have you done any mods to the rifle?

Posted: 9/20/2008 1:33:39 PM EDT

[#2]

Did your trigger return spring/plunger fall out some how ? You should be able to see it without taking anything apart, a plunger pushes against the back of the trigger to reset it between shots. If it is not that, than maybe your sear spring?

Posted: 9/20/2008 2:53:18 PM EDT

[#3]

I had the same problem if I am reading your post right. One pin in my trigger group was drifting out after x amount of firing and it was a huge irritation. Try taking it down and making sure all pins involving the trigger group are flush. Mine kept doing it but some strong threaded heavy duty tape keeps the pin in check now. Hope that helps!

Posted: 9/20/2008 3:56:12 PM EDT

[#4]

I noticed the trigger pin slipped out, I repositioned the trigger and it seems to be acting normal

Thanks for the advice

[ARCHIVED THREAD] - Ruger 10/22 problem

Armory Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - Ruger 10/22 problem

[ARCHIVED THREAD] - Ruger 10/22 problem