Armory Sponsor
Posted: 9/21/2016 9:55:57 PM EDT
|
I would really like to run it suppressed but need to thread the barrel first.
Whats the story on this? I hear the barrels are too thin to do this though I hear of it being done. Is my best bet sending it to ADCO? I know they will say they do it all the time with no problems but whats the hives success rate with this? any other places to send it that is reputable? Will the new muzzle device need to be pinned on like the original? |
|
Only 2 choices in my opinion. Either ADCO or Marvin Pitts at nefarious arms (former knights armament gun designer).
I had my fs2000 cut by adco and could not be happier. Had barrel cut to 16.1 inches. By complete accident I found out that that barrel length is perfect because your adverse setting now works perfect for non suppressed and normal works perfectly for suppressed. You don't have to pin unless you go under 16 inches but I have to say 14.5 with a pinned muzzle device looks amazing. Here is 16.1 with a yhm qd mount. 
|
Armory Sponsor