Warning

 

Close
Confirm Action

Are you sure you wish to do this?

Cancel Confirm
AR15.COM
5/15/2011 9:43:47 PM EDT
So I got a double case.



Without unpacking it compleatly



I don't see any directions.



Can't find much on their site etc.



Any tips would be appreciated
5/15/2011 9:47:35 PM EDT
[#1]
If I remember correctly there should be a measure scoop in the pack for the aluminum powder
5/15/2011 9:49:56 PM EDT
[#2]
two scoops of powder per 1/2 lb charge. Boom


5/15/2011 9:52:32 PM EDT
[#3]
F their directions, its a video of them blowing crap up with various weapons.  I found that if I was going to use it all in a session, to take all the contents and mix them, then distribute them. I ended up with about three extra target jars.  The key is to have the containers of white pellets full, before adding the right ratio of grey powder.   I never had the patience to figure out which was enough to make them go boom just right, and having enough to make targets out of everything that was included.  Plus once you mix it all together you can use other things for containers........... Like 2 liter bottles
5/15/2011 9:55:01 PM EDT
[#4]
Quoted:
two scoops of powder per 1/2 lb charge. Boom



no.  1 leveled spoonful.  too much and it runs fuel rich.  this comes from the man himself.
5/15/2011 9:57:48 PM EDT
[#5]
That stuff is awesome, just be aware that anything that you place it inside of or behind will probably become a high velocity piece of shrapnel.

Be safe, and enjoy!
5/15/2011 10:01:35 PM EDT
[#6]
Their instuctional video will not load for me?



I did find a hint to wrap the target in duct tape.
5/15/2011 11:03:18 PM EDT
[#7]
I usually by it in bulk and mix it in a gallon size ziploc bag and then portion it out into smaller ziplocs.  I then give the little bags a wrap of duct tape and an orange paster target.  
5/15/2011 11:13:12 PM EDT
[#8]
From their site:





http://www.tannerite.com/frequent-questions/





1 LEVEL teaspoon/5cc (one scoop) per 1/2 pound target.   If you use too
much catalyst, it will be "Fuel-rich”, not unlike a carburetor that is
oxygen-lean, and you will get a sluggish explosion or none at all.  For
one pound targets, you have two options. You can simply double the
amount of catalyst (two scoops/teaspoons per pound).  Just don’t more
catalyst than is recommended.



ETA:



Their two options (only one listed), not mine.





5/15/2011 11:21:04 PM EDT
[#9]
Ok, I think I got it now. Thanks