Warning

 

Close
Confirm Action

Are you sure you wish to do this?

Cancel Confirm
17531 Online
bravocompany bravocompany bravocompany
brownells brownells
tnvc tnvc tnvc
AR15.COM
bravocompany
My Account
bravocompany bravocompany bravocompany
brownells brownells
tnvc tnvc tnvc
brownells
Guns
DFC
JRH
RS
skd
geissele
midwest
silencerShop
vortex
GS
CA
aim
springfield
cz
magpul
colt
fightlite
Holosun
bravocompany
primaryArms
palmetto
17531 Online
primaryArms
springfield
bravocompany
CA
fightlite
skd
geissele
JRH
Holosun
magpul
brownells
vortex
midwest
cz
Guns
RS
DFC
colt
aim
silencerShop
GS
palmetto
Site News The People of Virginia VS Grabigial BanBerger | ARFCOM News
11/21/2011 7:25:00 PM EDT
sorry for the ignorance, but i have a problem with my 22/45.  there is a of the hammer assembly hanging down and its blocking the mainspring assembly from going all the way in (shown in the pictures).  i don't know how it happened, but it was fine during the first trip to the range (just over 200 rounds fired), but now its like this.  how do i fix it and keep it from happening again?
http://i56.photobucket.com/albums/g180/bushMASTER06/DSCN1400a.jpg
http://i56.photobucket.com/albums/g180/bushMASTER06/DSCN1401a.jpg
11/21/2011 7:28:22 PM EDT
[#1]
That's the part that goes into what you took off, no ?
11/21/2011 7:35:37 PM EDT
[#2]
i don't think so.  it looks like there is a pin going through the top of that part, attaching it to the hammer.
11/21/2011 7:40:33 PM EDT
[#3]
When I took my Mark III apart that black piece has to fit into the rear mechanism in order for it to seat properly, have your googled the reassembly of your particular model, it differs when you go on the Ruger website.
11/21/2011 7:42:18 PM EDT
[#4]
yeah, i've taken it apart and put it back together several times before this happened.
11/21/2011 8:07:47 PM EDT
[#5]
your hammer is in the cocked position instead of the fired.  Point the frame down and pull the trigger and shake the frame till the hammer falls in the fired position
11/21/2011 8:12:49 PM EDT
[#6]
i've done that and that little part still flops around blocking the mainspring assembly.
11/22/2011 3:29:54 AM EDT
[#7]
When reassembled, the end of that little strut has to fit into the pocket on the top of the MSH. It's how the hammerspring drives the hammer home when the sear is released by the trigger.
11/27/2011 5:59:43 PM EDT
[#8]
finally got it all put back together.  apparently the moon has to be in its final phase, you have to stand on one leg and think happy thoughts.  and then there's that whole knowing what you're doing thing.
cmmg
SAS
CA
ar15com
fightlite
Faxxon
bravocompany
gray
palmetto
springfield
blackhills
LAPG
geissele
ar15com
THBRD
RS
Pro2A
ar15com
brownells
primaryArms
LAPG
silencerShop