Posted: 10/8/2011 10:51:13 AM EDT
|
Tend to see the Glock dealer at each gun show and always see ads about replacing the Trigger Stop Connector.
Anyone replace this part with either a factory, Ghost or Lone Wolf one? Did you find it worth swapping out or basically no difference? Is one brand better than another? |
|
I replaced the standard connector in my Gen3 G27 with a "dot" aka "Gen4" connector made by Glock. It was made by Glock to bring the trigger pull weight of a Gen4 down to the same weight as a Gen3 with standard connector. One of the reasons a Gen4 trigger pull is heavier is that Glock changed the angle at which the connector sits in the trigger housing by 5 degrees in the Gen4 trigger housing.
To me it feels like basically the same trigger pull and reset, but lighter with no "wall" right before the trigger breaks. I like it a lot. Gen3: standard connector: 5.5lbs "dot" connector: 5lbs "minus" connector: 4.5lbs Gen4: standard connector: 6lbs "dot" connector: 5.5lbs "minus" connector: slighty more than 4.5lbs (weights are approximate) |