Hey, I know you can get a 9mm conversion barrel for a 23, but will this work the other way around? is there a way to shoot .40 out of a glock 19?
Thanks,
Tom
Posted: 3/6/2009 7:46:04 AM EDT
[#1]
Quoted: Hey, I know you can get a 9mm conversion barrel for a 23, but will this work the other way around? is there a way to shoot .40 out of a glock 19?
Thanks,
Tom
IIRC you need the 23 slide and barrel.
Posted: 3/6/2009 8:52:24 AM EDT
[#2]
The hole in the slide for the barrel is too small. Its easier to just buy a G23.
Posted: 3/6/2009 6:36:40 PM EDT
[#3]
The breachface on the 9mm is cut for the width of the 9mm's case rim diameter (plus about .050"). The casing rim on a 40cal won't fit in the breach face cut of a 9mm because it's too large in diameter.
Posted: 3/6/2009 6:43:43 PM EDT
[#4]
ok, thanks guys, I was just wondering.
Thanks again,
Posted: 3/6/2009 6:51:49 PM EDT
[#5]
Lone wolf sells slides and barrels, and I was wondering the same thing... with a slide/barrel conversion and mags could I get m y G19 to fire .357sig?
Posted: 3/6/2009 11:21:50 PM EDT
[#6]
Quoted: ............................. with a slide/barrel conversion and mags could I get m y G19 to fire .357sig?...
If you have a G19 that was produced AFTER '02 that has all 3 receiver pins then yes, if it only has 2 then no.
