B.A.D. based build

jrs93accord

Member

Joined: Jul 2005

Posts: 5482

EE: 100% (56)

FL, USA

Posted: 2/29/2016 7:00:40 PM EDT

[Last Edit: jrs93accord][Edited]

A few weeks ago, I received my B.A.D. LW receiver set from Tactical Link. I had also acquired a few other B.A.D. pieces from Tactical Link and from B.A.D. as well. The lower receiver has been built as of a couple weeks ago. The upper is with my gunsmith along with the 18" LaRue Tactical Stealth barrel. The barrel is getting M4 cuts put into the barrel extension so it will match up with the upper receiver's M4 feedramps.

Here are the specs on this B.A.D. based build:

Upper Assembly:
Battle Arms Development BAD556-LW Lightweight 7075-T6 Billet Upper Receiver
LaRue Tactical 18" Stealth Barrel w/ mid-length gas system
LaRue Tactical LT202 Low-Profile Gas Block, Gas Tube and Gas Tube Pin
SLR Rifleworks Synergy BCF 5.56 Mod 1
LANTAC Enhanced Bolt Carrier Group
Strike Industries AR-15 Charging Handle w/ Extended Latch
FORTIS SWITCH 556 Rail System 14"
FORTIS SWIFT Short Angled Fore-End Grip (Keymod)
MAGPUL MBUS PRO Front and Rear Sights
American Defense RECON-X 30mm mount
VORTEX Strike Eagle 1-6x24 scope

Lower Assembly:
Battle Arms Development BAD556-LW Lightweight 7075-T6 Billet Lower Receiver
Battle Arms Development BAD-EMMR Enhanced MODULAR Magazine Release - LARGE / BLACK
Battle Arms Development BAD-ASS-LW Ambi Safety Selector
Battle Arms Development BAD-EPS (Enhanced Pin Set) AR15
Norgon Ambi-Catch™ Magazine Release
Forward Controls Augmented Bolt Catch/Release, Forged (ABC/R-F)
Executive Ordnance "Molon Labe" Pistol Grip w/ Stealth G-10 Panels (Blk)
BCM A5 Intermediate Buffer System Assembly
MFT Battlelink Minimalist Stock (Blk)
Elftmann Tactical 3 Gun Single Stage Curved Bow Modular Trigger
KNS Precision hammer/trigger pins