Posted: 8/4/2012 6:14:28 AM EDT
|
I think I am about to order one of your 10.3" barrels with a lpgb pre-installed. Just wondering how hard it will be to remove this to get the barrel nut on? Also, how hard will it be to get it to seat properly again?
Thanks, Adam |
|
Quoted:
I think I am about to order one of your 10.3" barrels with a lpgb pre-installed. Just wondering how hard it will be to remove this to get the barrel nut on? Also, how hard will it be to get it to seat properly again? Thanks, Adam if you have a punch and a hammer, and two working appendages, its a cinch. The gas block is pinned on and there is a taper reamed hole which a tapered pin is installed into, similar to FSB. all you have to do it tap it out, remove the gas block, put your barrel nut on, and slide the gas block back to where it was. the pin hole is drilled through the gas block and the barrel, there is no difficulty in putting it back to where it was, the pin can only go one way. well more or less, you could use a sledge on it and make it go the other way 
|