Posted: 3/9/2012 6:22:36 PM EDT
I took my SD-3G out of my lower for detailed cleaning, and noticed that one of the legs of my trigger spring is bent up a little (pictures below). I'm pretty sure it wasn't this way when I installed it, and it was installed correctly. I also doubt I could have accidentally bent it this way while removing it off the trigger. Any ideas on what could have bent it like this? And more importantly, should I just bend it back and forget about it? I'm assuming that right leg should be straight, just like the left one, correct? Thanks in advance for your help.
|
|
Quoted:
Quoted:
Aleko Your spring was most likely bent during installation of the trigger. Please contact the shop for a replacement. JB Geissele Automatics 610-272-2060 Thanks. I will call on Monday. Is it OK to just bend it back and keep using it? At least for now? Yes, it will work just fine. 
|