I need to make some bends in an approximately 1'x1.5' sheet of 3/32nd acrylic
1) Will I deeply regret using my oven for this?
2) If no, around what temperature should I toss that bad boy in, in order to have it flexible enough for <90 degree bends, for say, 10 seconds?
I tried a heat gun with the first attempt, I didn't get it evenly heated over the whole run. Managed to get a nice crack at the one edge
I figure with the oven it should be more even and I can get at least one of the bends, approximately, with some foil underneath.
Thanks for any help